Spalted Maple 3 Drawer with Bark

This 2 drawer log box is made from a solid piece of Spalted Maple wood. The green material throughout the piece is where natural splits/ holes were in the wood that I then filled in with a green colored resin to help give it back some structural strength and a fun pop of color. I was able to keep the original bark on the log and it is held down with a combination of resin, glue, and wood finish. I left the two drawers UN-lined. The piece has also been coated in Danish Oil finish, which soaks into the wood and hardens it from the inside out so you should never have to worry about doing anything to it and just enjoy its beauty over the years. If you even need to dust the bark off, I recommend using a little can of air to blow the dust off the piece since rags will just snag on the bark.

General Over All Measurements:

Height: 6 inches 

Width(side to side): 9.5 inches 

Depth(front to back): 5 inches 

Approximate Interior Drawer Measurements:

Top Right Drawer

Height: 2 inches 

Width(side to side): 2.25 inches 

Depth(front to back): 3.25 inches 

Top Left Drawer

Height: 2 inches 

Width(side to side): 1.75 inches 

Depth(front to back): 3.25 inches 

Bottom Drawer

Height: 1.75 inches 

Width(side to side): 5.75 inches 

Depth(front to back): 3.5 inches 

**Disclaimer! The measurements of these pieces are not exact and there are some variations throughout the piece because these are cut out organically and are not made to be perfect sizes**

Please don't hesitate to message me with any questions!